Place a battery module in the upper enclosure, then slide the brackets inward on each side. Connecting Batteries CAUTION – Do not reverse positive and negative power connections. . Battery locations shall conform to 480. Provisions shall be made for sufficient diffusion and ventilation of the gases from the battery to prevent the accumulation of an explosive mixture. Servicing of batteries should be performed or supervised only by properly trained and ries are an energy source that can produce high e protection should be worn to prevent injury from Use double insulated tools. . intenance should always be performed with heavily insulated tools. It is also recommended to wear rubber gloves, boots, at ry cabinet, such as freight ele ators, pallet jacks and forklifts. (Fully extend f rks under load. The supplied wrench can be used to adjust the wheel height to acheive proper. . The positioning of the battery room must be in close proximity to the UPS modules being supported. Use appropriate hardware for the mounting surface. Drill 2” deep holes with an 5/16” bit WARNING – the door has a grounding wire and display cable attached to. .
